Why My Netgear Extender Keep Disconnecting During Setup?

No doubt – performing Netgear extender setup is one of the best ways to access the lag-free internet connection in every nook and cranny of house. Apart from that, we also can’t deny the fact that like any other device, Netgear extenders are also prone to various technical issues. And, the most common issue that every third user comes across is that their Netgear extender keep on disconnecting during setup.

On the off chance if you are also struggling with the same issue, then it’s high time that you walk through the Netgear extender troubleshooting tips highlighted below. We assure you that – by the time you reach the end of this article, the Netgear extender keep disconnecting issue would have gone far away. So, without further ado, let’s get started.

Reasons Why Your Netgear Extender Keep Disconnecting During Setup

Before you learn how to fix the annoying issue, bear in mind that you need to be aware of the reasons first behind the issue. In this way, it will be easier for you to deal with the issue. Keep scrolling down!

Highlighted below is the list of the reasons why your Netgear extender keep disconnecting during setup:

  • The placement of your Netgear extender is not ideal
  • The firmware of your extender is not up-to-date
  • You haven’t performed the Netgear extender setup process correctly
  • Your router is not connected to Netgear_ext during the setup process

Keeping the abovementioned points in mind, move a step forward and know how to resolve Netgear extender keep disconnecting during setup issue in a jiffy. Scroll down a little!

Check the Placement of Your Netgear Extender

The wrong or incorrect placement of your Netgear WiFi extender is one of the biggest reasons behind the issue. To fix the issue, highlighted below are some important points that you need to consider. Continue reading!

  • Position your Netgear extender on a neat and higher area.
  • Do not place the device too closer to roof or fall ceiling.
  • Keep your extender at the center-most area in your home.
  • Do not place your Netgear device inside a cupboard, behind curtains or near to corners.

Connect Your Router to Netgear_ext

Another main reason why you are facing Netgear extender keep disconnecting during setup issue is because your router isn’t connected to Netgear_ext securely and properly. Thus, ensure to connect your devices securely with each other.

Note: Instead of using a wireless source, connect your router and extender using a wired source. But, make sure to use a non-damaged Ethernet cable to connect your Netgear device and router.

In the event that the Ethernet connection doesn’t work for you, then power cycle or reboot your extender once.

To reboot the device, do the following:

  • Disconnect your router from Netgear_ext.
  • Unplug your extender from the wall socket and wait for a couple of minutes.
  • Plug the Netgear device back in.
  • Try to access mywifiext setup page to see if the issue still persists.

Update the Firmware of Your Extender

In the event that none of the Netgear extender troubleshooting tips helped you out, then chances are that your device is operating on an outdated firmware version. If so, then its high time to update the firmware of your extender right away.

To update the extender’s firmware, connect your router to Netgear_ext, navigate to mywifiext setup page, locate and click on the firmware update button, and follow the on-screen instructions.

Once you update the firmware of your extender, try to access the mywifiext setup page using 192.168.1.250 IP, and check whether the issue is fixed or not.

The Last Words

If you aren’t able to fix Netgear extender keep disconnecting during setup issue, then it is highly recommended – without much delay – drop your queries into the comments section.

Read more: Netgear Router Setup: Things You Need To Know

LEAVE A REPLY

Please enter your comment!
Please enter your name here